Filter
Top Products
Command Line Interface
4-254
4
Routing Information Protocol (RIP)
router rip
This command enables Routing Information Protocol (RIP) routing for all IP
interfaces on the router. Use the no form to disable it.
Syntax
[no] router rip
Command Mode
Global Configuration
Default Setting
Disabled
Command Usage
• RIP is used to specify how routers exchange routing table information.
• This command is also used to enter router configuration mode.
Example
Related Commands
network (4-256)
Table 4-86 Routing Information Protocol Commands
Command Function Mode Page
router rip Enables the RIP routing protocol GC 4-254
timers basic Sets basic timers, including update, timeout, garbage collection RC 4-255
network Specifies the network interfaces that are to use RIP routing RC 4-256
neighbor Defines a neighboring router with which to exchange information RC 4-256
version Specifies the RIP version to use on all network interfaces (if not
already specified with a receive version or send version
command)
RC 4-257
ip rip receive version Sets the RIP receive version to use on a network interface IC 4-258
ip rip send version Sets the RIP send version to use on a network interface IC 4-259
ip split-horizon Enables split-horizon or poison-reverse loop prevention IC 4-260
ip rip authentication key Enables authentication for RIP2 packets and specifies keys IC 4-260
ip rip authentication
mode
Specifies the type of authentication used for RIP2 packets IC 4-261
show rip globals Displays global configuration settings and statistics for RIP PE 4-262
show ip rip Displays RIP configuration information for each network interface PE 4-262
Console(config)#router rip
Console(config-router)#