Filter
Top Products
Printer Panel 1
– 28 –
4581-7777-01
7. Measure margin a from the edge of the
paper to the pattern printed in the test page,
and then check that the width of the mea-
sured margin meets its standard width.
Standard width of the margin (a):
3.0 mm ± 1.0 mm
If the width of the measured margin does not
meet its standard width, follow the procedure
in the next section, follow the instructions
described below. Position for PF-118, to
adjust it.
C4658U028AA
a
Paper Exit
Direction
8. Select the paper drawer that you wish to
adjust, and then click the up and down
arrows in the lower-right corner of the screen
to enter the difference between the mea-
sured width and the standard width.
9. Print a test page and check the paper refer-
ence position.
If the width of the measure margin does not
meet its standard width, follow the instruc-
tions described below.
10. Open the paper drawer for the cassette that
needs to be adjusted, and then remove all of
the paper.
11. Loosen the two screws on the guide plate at
the bottom of the paper drawer.
C4658U024AA
12. Adjust the guide plate to the appropriate
position on the scale inside the paper
drawer.
13. Check that the message displayed in the
printer panel changes from “Alert Printing
suspended” to “Info”.
14. Exit the External Panel Controller.
C4658U025AA