Filter
Top Products
Loading for Peel Mode–––––––––––––––––––––––––––––––––––––––
In Peel mode, use die-cut labels only. Use supplies up to a
maximum of 2.05 inches. Contact Monarch at the number at
the back of this manual if you have special label requirements.
nIt doesn’t matter if the printer is off or on while you are loading
supplies.
To load supplies for Peel mode:
1. Remove the supply holder from the supply well as shown.
2. Push the printhead lever up to open the printhead.
Supply
Holder
Printhead
Lever
Support Frame
Ta b s
Supply
Well
9450 Operator’s Handbook
2-2