Filter
Top Products
4. Drop the new supply roll into the supply well until it rests
on the back wall.
5. With thumb and forefinger, insert the leading edge of the
supply into the supply guide until the printer begins to feed
the supply. Make sure the supply roll is flush against the
back wall when you begin to insert the leading edge.
6. Replace the supply holder.
nTo manually load supplies with the printer turned off, you must
insert the leading edge of supply into the supply guide and
then turn the printhead knob clockwise. This will manually feed
the supply through.
Supply
Guide
Supply
Well
Leading
Edge of
Supply
Knob
Chapter 2. Loading Supplies
2-7