Filter
Top Products
EDS-408A/405A Series User’s Manual Featured Functions
3-47
Monitor by Port
Access the Monitor by Port function by selecting ALL 10/100M Ports or Porti, in which i= 1,
2… 8 etc., from the left pull-down list. The Porti options are identical to the Monitor by System
function discussed previously, in that users can view graphs that show Total Packets, TX Packets,
RX Packets, or Error Packets activity, but in this case, only for an individual port.
The All
10/100M Ports option is essentially a graphical display of the individual port activity that can be
viewed with the Console Monitor function discussed above. The All 10/100M Ports option shows
three vertical bars for each port. The height of the bar represents Packets/s for the type of packet,
at the instant the bar is being viewed. That is, as time progresses, the height of the bar moves up or
down so that the user can view the change in the rate of packet transmission. The red colored bar
shows Uni-cast packets, the green colored bar shows Multi-cast packets, and the blue colored bar
shows Broad-cast packets. The graph is updated every few seconds, allowing the user to analyze
data transmission activity in real-time.
Using the MAC Address Table
This section explains the information provided by MOXA EtherDevice Switch’s MAC address
table.
The MAC Address table can be configured to display the following EDS MAC address groups.
ALL Select this item to show all EDS MAC addresses
ALL Learned Select this item to show all EDS Learned MAC addresses
ALL Static Lock Select this item to show all EDS Static Lock MAC addresses
ALL Static Select this item to show all EDS Static/Static Lock /Static Multicast
MAC addresses
ALL Static Multicast Select this item to show all EDS Static Multicast MAC addresses
Port x Select this item to show all MAC addresses of dedicated ports