Filter
Top Products
Technical Configuration MultiVOIP User Guide
60
17. Set NAT Traversal (STUN) parameters. Optional. Applicable only
under SIP Call Signaling when the UDP transport protocol is used.
18. Set RADIUS parameters. Optional. Used only if system interfaces
with RADIUS server for billing or other accounting functions.
19. Set Baud Rate (of COM port connection to ‘Command’ PC).
20. View System Info screen and set updating interval (optional).
21. Save the MultiVOIP configuration.
22. Create a User Default Configuration (optional).
When technical configuration is complete, you will need to configure
the MultiVOIP’s inbound and outbound phonebooks. This manual has
separate chapters describing T1 Phonebook Configuration for North-
American-influenced telephony settings and E1 Phonebook
Configuration for Euro-influenced telephony settings.
Local Configuration Procedure (Detailed)
You can begin the configuration process as a continuation of the
MultiVOIP software installation. You can establish your configuration
or modify it at any time by launching the MultiVOIP program from the
Windows Start menu.
1. Check Power and Cabling. Be sure the MultiVOIP is turned on and
connected to the computer via the MultiVOIP’s Command Port (DB9
connector at computer’s COM port; RJ45 connector at MultiVOIP).
2. Start MultiVOIP Configuration Program. Launch the MultiVOIP
program from the Windows Start menu (from the folder location
determined during installation).