Chapter 5 – AT Commands, S-Registers, and Result Codes
Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer’s Guide 74
Command: +PSS Use Short Sequence
Description: Causes a calling modem to force either a V.92 short or full startup
sequence as defined by the +PQC command on the next and subsequent
connections.
Defined Values: +PSS0 The modems decide whether or not to use the short startup
procedures. The short startup procedures can only be used if
enabled by the +PQC command. (Default.)
+PSS1 Reserved.
+PSS2 Forces the use of the full startup procedures on the next and
subsequent connections independent of the setting of the
+PQC command.
Result Codes: OK 0 - 2 in V.92 Mode (+MS=V.92)
ERROR
Report Commands: +PSS? Reports Selected Values.
Response: +PSS: <value>
Example: +PSS: 0 For the default <value>.
+PSS=? Reporting Supported Range of Parameter Values:
Response: +PSS: (<value> range)
Example: +PSS: (0,1,2)
Command: -QCPC Force Full Startup Procedure on Next Connection
Description: Causes the modem to use full startup procedures on the next connection
attempt regardless of the setting of the +PQC command. After this attempt,
the modem will select the startup procedure as defined by the +PQC
command. If a shortened startup procedure is enabled by the +PQC
command, then the quick connect profile will also be updated on the next
connection attempt.
Result Code: OK In V.92 Mode (+MS=V.92)
ERROR
Command: -QCPS Enable Quick Connect Profile Save
Description: This command controls whether or not the modem will save the generated
quick connect profile.
Defined Values: -QCPS0 Do not allow the quick connect profile to be saved.
-QCPS1 Allow the quick connect profile to be saved. (Default.)
Result Codes: OK in V.92 Mode (+MS=V.92) and quick connect is enabled (+PSS = 0)
ERROR
Report Commands: -QCPS? Reports Selected Value(s).
Response: -QCPS: <value>
Example: -QCPS: 1 For the default setting.
-QCPS=? Reports Supported Range of Parameter Values.
Response: -QCPS: (<value> range)
Example: -QCPS: (0,1)