Multi-Tech Systems MVP210-SS Network Card User Manual


 
MultiVOIP User Guide QS: Startup Tasks
24
MultiVOIP Startup Tasks
Task Summary
Collecting Phone/IP
Details ( vital! )
The MultiVOIP must be configured to
interface with your particular phone
system and IP network. To do so,
certain details must be known about
those phone and IP systems.
Placement
Decide where you’ll mount the voip.
Command/Control
Computer Setup:
Specs & Settings
Some modest minimum specifications
must be met. A COM port must be set
up.
Hookup Connect power, phone, and data cables
per diagram.
Software Installation This is the configuration program.
It’s a standard Windows software
installation.
Phone/IP Starter
Configuration
You will enter phone numbers and IP
addresses. You’ll use default parameter
values where possible to get the system
running quickly.
Use “Config Info CheckList” (page 28).
Phonebook Starter
Configuration
The phonebook is where you specify
how calls will be routed. To get the
system running quickly, you’ll make
phonebooks for just two voip sites.
Connectivity Test You’ll find out if your voip system can
carry phone calls between two sites.
That means you’re up and running!
Troubleshooting Detect and remedy any problems that
might have prevented connectivity.