Filter
Top Products
MultiVOIP User Guide QS: Phone/IP Starter Config.
35
4. Web Browser GUI Setup (Optional). To do configuration and
operation procedures using the web browser GUI, you must first set
it up. To do so, follow these steps. (The browser used must be
Internet Explorer 6.0 or above; or Netscape 6.0 or above; or FireFox
1.0 or above.)
A. Be sure an IP address has
been assigned to the
MultiVOIP unit (this must be
done in the MultiVOIP
Windows GUI).
E. Open web browser.
(Note: The PC being used must
be connected to and have an IP
address on the same IP network
that the voip is on.)
B. Save Setup in Windows GUI. F. Browse to IP address of
MultiVOIP unit.
C. Close the MultiVOIP
Windows GUI.
G. If username and password
have been established, enter
them when prompted by
voip.
D. Install Java program from
MultiVOIP product CD.
(Must be Java Runtime
Environment 1.4.2_01 or above.)
NOTE: Required on first use of
Web Browser GUI only.
H. Use web browser GUI to
configure or operate voip.
Need more
info?
See “Web Browser Interface” in Operation &
Maintenance chapter of User Guide (on CD).
Once you’ve begun using the web browser GUI, you can go back
to the MultiVOIP Windows GUI at any time. However, you must
log out of the web browser GUI before using the MultiVOIP
Windows GUI.