Multi-Tech Systems MVP210-SS Network Card User Manual


 
MultiVOIP User Guide Technical Configuration
93
Write down the values for these IP parameters. You will need to enter
these values in the “IP Parameters” screen in the Configuration section
of the MultiVOIP software. You must have this IP information about
every VOIP in the system.
Telephony Interface Parameters
The following parameters must be known about the PBX or telco
central office equipment to which the analog MultiVOIP will connect:
Phone Parameters
Ask phone company or
telecom manager.
Telephony Interface Parameters:
Record for this VOIP Site
#
Which interface type is to be used?
E&M_____ FXS/FXO_____ DIP/DPO _____
If FXS, determine whether the line will be used for a
phone, fax, or KTS (key telephone system)
If FXO, determine if line will be an analog PBX
extension or an analog line from a telco central office
If E&M, determine these aspects of the E&M trunk
line from the PBX:
What is its Type (1, 2, 3, 4, or 5)?
Is it 2-wire or 4-wire?
Is it Dial Tone or Wink?