National Instruments NI 6239 Switch User Manual


 
Chapter 4 Analog Input
© National Instruments Corporation 4-25 NI 6238/6239 User Manual
Routing AI Pause Trigger Signal to an Output
Terminal
You can route ai/PauseTrigger out to RTSI <0..7>.
Note Pause triggers are only sensitive to the level of the source, not the edge.
Getting Started with AI Applications in Software
You can use the M Series device in the following analog input applications.
Single-point analog input
Finite analog input
Continuous analog input
You can perform these applications through DMA, interrupt, or
programmed I/O data transfer mechanisms. Some of the applications also
use start, reference, and pause triggers.
Note For more information about programming analog input applications and triggers in
software, refer to the NI-DAQmx Help or the LabVIEW 8.x Help.