Filter
Top Products
Installing and Using Utilities 5-27
Printer Information’s Available Time:
When you add a new printer, install its driver and make its settings, if you do not make settings for
the available time from Add Printer Wizard, the printer’s available time (From and To) in [Printers
and Faxes] are [00:00], on the other hand, Manager’s time are [9:00]. To display them properly,
make the settings of printer from [Printers and Faxes]. The procedures are as follows;
1. Start [Printers and Faxes], and open the printer properties you want to make settings
for. (Select the [Printers and Faxes], right-click and select [Properties].)
2. Select the [Advanced] tab.
3. Enter values in the available time (From and To), and click [OK] in the [Advanced]
and [Properties] dialog boxes.
Now, you can see the correct information from Manager, too.
Hang of SNMP Service
SNMP Service has a module called “SNMP Extended Agent.” This module may be registered when
you install some software that uses SNMP Service.
If you start SNMP Service, SNMP Extended Agent is also loaded at the initialization. However, if
the initialization is not completed within a specified period, SNMP Service will hang.
It may take time to complete the initialization due to temporary high load on the system. In this case,
wait for the system load become low enough before restarting SNMP Service.
Model Name of CPU/PCI module
If you select [CPU/PCI Module]-[Each CPU/PCI Module]-[General Information/Update
Information] in [FT Server] tree of the data viewer, the displayed “Model Name” information is not
correct.
To check the “Model Name”, refer to the Part Number of Board Information displayed by selecting
[Hardware]-[Field Replaceable Unit]-[Each CPU/PCI Module] in [ESMPRO] tree of the data
viewer.