Filter
Top Products
E-28
9
8
Main control
ON/STANDBY
Remote control
ON/
STANDBY
When You Have Finished Using Your Projector
8 Turn off the lamp.
Press the ON/STANDBY button.
“Press ON/STANDBY switch again to turn off” appears on the
projected image.
Press the ON/STANDBY button again.
The LAMP indicator blinks in green and turns off in two
minutes.
The POWER indicator turns on in red.
NOTE
If you press the ON/STANDBY button while the LAMP indicator is blinking in green, the lamp lights again.
If you press it again, the unit enters the standby mode.
9 Pull out the power cable.
The POWER indicator on the operation panel goes out.
CAUTION
• Do not pull out the power cable from the power outlet before turning off the lamp or the LAMP indicator
turns off. Doing so may shorten the useable life of the lamp.
• If you are not going to use your projector for an extended period, disconnect the power cable from the power
outlet.
•Wait a predetermined time (about 10 seconds) before you turn the power on after turning it off.
NOTE
• Due to its characteristics, the lamp may not light if it is turned on immediately after having been turned
off. Wait one minute or more and turn it on again.
• The lamp may sometimes emits a slight humming sound when on. This is normal.
POWER
LAMP
ALARM