NEC DT100 Projector User Manual


 
E-49
Troubleshooting
Model Number
Optical
LCD panel Size
Drive method
Number of pixels
Arrangement
Lens
Lamp
Image size / Projection Distance
Electrical
Color reproduction
Scanning frequency
Display of available resolution (RGB signal input)
OHP Scanner
Scan speed
Scan size
PC Signal system
(Analog Video signals
RGB Input
) Synchronizing
signals
Input terminal
Video Signal system
Input terminals
Monitor Video signal
output
Synchronizing signals
Output connector
PC Audio signal
Video Input terminal
Monitor Audio signal
output Output terminal
Audio output
Ambient temperature and humidity
Storage temperature and humidity
Power requirement
Mechanical
External dimensions
Weight
Accessories
Regulations
Specifications
Video I/O
Audio input
DT100
1.3-in.(3 panels) Aspect ratio 4:3
Polysilicon TFT active matrix with micro lens array
786,432 pixels (1,024 dots x 768 dots) x3
Stripe
Manual zoom X1-1.3, f=49mm -64 mm, F1.7-2.3
200W New Super High pressure lamp
Min. 30-in. (focal distance 1.43m/56.3")
Max. 300-in. (focal distance 14.86m/585")
Full color (16,770,000 colors)
Horizontal: 15 to 80kHz, Vertical: 50 to 75Hz
1
,024
x 768 dots (1,280 x 1
,024
dots compressed display available)
1/2-in. single plate CCD camera (2,000,000 pixels)
4 frames/sec
At 100%: 288mm x 216mm/11.3" x 8.5", At 200%: 144mm x 108mm/5.7" x 4.3"
Separate signal system
Analog: 0.7Vp-p/75
Separate/composite: TTL level (posi/nega)
Sync on green: 0.3Vp-p (nega)
15-pin mini D-Sub
NTSC, PAL or SECAM
RCA pin jack x 1, S-video terminal (mini DIN 4-pin) x 1
0.7Vp-p/75
Separate TTL level, negative polarity
15-pin mini D-Sub x 1
0.4Vrms/47K
RCA pin jack (PC and video, 1 each)
0.4Vrms/47K 1
Stereo mini jack
Built-in 2Wx2/8 speaker (stereo)
Temperature: 0 to 35°C/32° to 95°F, Humidity: 20 to 80% (no condensation allowed)
Temperature: -10° to 50°C/14° to 122°F, Humidity: 20 to 80%
100-120/220-240V AC 50/60Hz, 4A/2A
390mm (W) x 380mm (D) x 190mm (H)/15.35" (W) x 14.97" (D) x 7.48" (H) (not including protrusions)
Approx. 8.5kg/18.74 lbs
Power cable, remote control, user's manual, batteries (SUM3/AA x 2) and
RGB signal cable.
UL Approved (UL 1950, CSA 950)
Meets DOC Canada Class A requirements
Meets FCC Class A requirements
Meets AS/NZS3548 Class A
Meets EMC Directive (EN55022, EN55024, EN61000-3-2, EN61000-3-3)
Meets Low Voltage Directive (EN60950, TUV GS Approved)
1 The input signal from the selected device is output.
Specifications and design are subject to change without prior notice in the interest of product improvement.
We provide more information about our projectors through the World Wide Web at http://www.nec-pj.com/
LCD panels are inherently susceptible to bad pixels.
The LCD panel may have pixel failures at the rate of 0.01% or less.