Filter
Top Products
E-21
3.
PROJECTING AN IMAGE (BASIC OPERATION)
This section describes how to turn on the projector and to project a picture onto the screen.
Turning on the Projector
NOTE:
• The projector has two power switches: a main power switch and an ON/STAND BY button.
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off (O)
position. Failure to do so may cause damage to the projector.
To turn on the main power to the projector, press the Main Power switch to the on ( I ) position.
The POWER indicator will light orange.
Before you turn on your projector, ensure that the computer or video source is turned on and that your lens cap
is removed.
Only after you press the ON/STAND BY button on the projector cabinet or POWER ON button on the remote
control for a minimum of 2 seconds will the power indicator turn to green and the projector become ready to use.
POWER
POWER POWER
STATUS
LAMP
STATUS
LAMP
STATUS
LAMP
Standby Blinking Power On
Steady orange light Blinking green
light
Steady green
light
See page E-49 for more details.
LAMP
STATUS
POWER
AUTO
ADJ.
ON/STAND BY
SELECT
SOURCE
MENU
POWER
OFF
S-VIDEO
C-VIDEO
VIDEO
COMP.
COMPUTER
COMPONENT
AUTO
AUTO ADJ.
ON
Remote controlCabinet controls
CONTROL
S-VIDE
O IN
R
Cb/Pb
Y
L/mono
STATUS
LAMP
POWER
NOTE: The POWER and STATUS (LED) indicators blinking green at the same time indicates the main power was interrupted
during previous operation. Wait for 60 seconds (cooling period) to see if the lamp turns on by itself.
3. PROJECTING AN IMAGE (BASIC OPERATION)