Filter
Top Products
9-8 Upgrading Your Server
Installation
Take the following steps to install a hard disk drive. This procedure applies to all the hard disk drive
bays.
NOTE: Any hard disk drive can be installed or removed in or from the
server only by removing the front bezel.
IMPORTANT: In the disk array configuration, use the hard disk drives
having the same specification including the capacity.
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
2. Unlock the front bezel with the security key and remove the front bezel.
3. Locate the slot in which you are going to install a hard disk drive.
The server has six slots. Install hard disk drives in ascending order of the SCSI ID or SAS
port numbers. The SCSI IDs or SAS port numbers assigned to the slots are all determined.
4. Remove the dummy block.
A dummy block is installed in the hard disk drive bays except the one with SCSI ID0 or
SAS Port 0.
IMPORTANT: Keep the dummy block for future use.
5. Unlock the lever of the hard disk drive carrier and open the handle.