Filter
Top Products
108
6. Using On-Screen Menu
Selecting Communication Speed [COMMUNICATION SPEED]
This feature sets the baud rate of the PC Control port (D-Sub 9 Pin). It supports data rates from 4800 to 38400 bps.
The default is 38400 bps. Select the appropriate baud rate for your equipment to be connected (depending on the
equipment, a lower baud rate may be recommended for long cable runs).
Your selected communication speed will not be affected even when [RESET] is done from the menu.
Turning On or Off Remote Sensor [REMOTE SENSOR]
This option determines which remote sensor on the projector is enabled in wireless mode.
The options are: front/back, front, and back.
Selecting Power-saving in [STANDBY MODE]
The projector has two standby modes: [NORMAL] and [POWER-SAVING].
Power-saving mode is the mode that allows you to put the projector in the power-saving condition which consumes
less power than the Normal mode. The projector is preset for Normal mode at the factory.
NOTE:
• The HTTP server functions are not available during POWER-SAVING mode.
• The MONITOR OUT function is not available during POWER-SAVING mode.
• Control through the PC Control connector and LAN mode is not available during POWER-SAVING mode. For PC control and LAN
mode of the projector it is recommended to leave the projector in the Normal mode.
NORMAL ....................... Power indicator: Orange light/Status indicator: Green light
POWER-SAVING ........... Power indicator: Orange light/Status indicator: Off