Filter
Top Products
Advanced
YML717 Rev1 NetComm NB5 Ethernet/USB Modem Router
www.netcomm.com.au 41
Select the encapsulation type (LLC or VC) according to information is provided by the ISP.
Select the VPI and VCI settings: 8/35 is default [recommended].
Username: Your ISP account ID e.g. <yourname@your_isp.com.au>
Password: ISP Account Password
On-Demand: Enables on-demand mode. The connection will be dropped if no activity is detected
after the specified idle timeout value [see next].
Idle Timeout: Specifies that PPPoA connection should disconnect if the link has no activity detected
for n seconds [see above]. If the link is to remain always active, enter 0 in this field.
Keep Alive: When the On-Demand option is not enabled, this value specifies the time to wait
without being connected to your provider before terminating the connection. To ensure that the link
is always active, enter '0' in this field.
Set Route: Check box to make this the default connection
MRU: This field sets the Maximum Receive Unit for the DSL connection. It is a negotiated value that
specifies the packet size of the data being sent from the DSL provider. This can be set from a
minimum 128 to maximum 1500.
Enforce MRU: Check this box if you experience problems accessing the Internet over a PPPoE
connection. This feature will force all TCP traffic to conform with PPP MRU by changing TCP
Maximum Segment Size to PPP MRU.
To complete and save the Connection Profile, click the Apply button, and then click on Save Settings
at the bottom of the menu list on left.