NetComm NB3100 Network Router User Manual


 
Rev.2 - YML630 www.netcomm.com.au
Cable/DSL Firewall Router Page 11
Chapter 2: Hardware Installation & Setup
This chapter provides information about your NetComm Cable/DSL Firewall Router’s physical
features and gives step-by-step installation instructions.
2-1 Rear Panel & Connections
The following figure shows the rear view of the NetComm Cable/DSL Firewall Router and
illustrates how the cables connect to the interfaces on the rear panel.
Plug one end of the UTP cable into the WAN port, the other into the RJ45 Ethernet jack on
your ADSL or Cable modem.
Connect a computer, with a Network Interface Card installed, to one of the four LAN Ports.
Connect the external power supply to the NetComm Cable/DSL Firewall Router.
The Reset button is used to reboot the device - press once quickly, or for clearing
configuration settings back to factory default values - press for 10 seconds.