Filter
Top Products
www.netcomm.com.au Rev.2 - YML630
Page 20 Cable/DSL Firewall Router
3-3 Initial Configuration – Setup
The “OnePage Setup” screen is the first screen you will see when you access the router’s
configuration. If the router has already been successfully installed and set up, this screen’s
values will already be properly configured. Below is a description of each setting.
■ Host Name This entry is required by certain ISPs.
■ Domain Name This entry is required by certain ISPs.
■ Time Zone: Select the time zone your location belong to from the pop-down list.
■ Private IP Address The Device IP Address and Subnet Mask of the router are used by the
internal LAN. The default values are 192.168.1.1 for IP Address and 255.255.255.0 for
Subnet Mask.
WAN Connection Type
There are a number of options for WAN connection types: Obtain IP automatically (eg Optus
Cable), Static IP, PPPoE (ADSL), HeartBeat (eg Telstra Cable) and PPTP. If you do not know
which connection type you currently use, contact your ISP to get the information.
Obtain IP automatically is the default option for the router. If your ISP automatically assigns
the IP addresses and other values to the NetComm Cable/DSL Firewall Router, use this option.