www.netcomm.com.au Rev.2 - YML630
Page 12 Cable/DSL Firewall Router
2-2 Front Panel LEDs
The following figure shows the front view of the NetComm Cable/DSL Firewall Router.
The LEDs on the front panel indicate the status of the unit.
Power: Green On when power is on.
Diag: Red Lights up during system check when the power is initially
connected. If the Router is working properly, the light should
switch off after the diagnostic has been completed.
WAN ports
Link/Act: Green On when ADSL/Cable Modem is properly connected and is
operating at 100Mbps.
Yellow On when ADSL/Cable Modem is properly connected and is
operating at 10Mbps.
Green/Yellow Blinking when data is flowing through the LAN port.
FD/Col: Green On when operating in full duplex mode.
Off in half duplex mode.
Blinking when a collision has occurred on this port.
LAN ports
Link/Act: Green On when link is up and is operating at 100Mbps.
Yellow On when link is up and is operating at 10Mbps.
Green/Yellow Blinking when data is flowing through this LAN port.
FD/Col: Green On when operating in full duplex mode.
Off in half duplex mode.
Blinking when a collision is occurring on this port.