NETGEAR RT314 Network Router User Manual


 
Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
11-6 Troubleshooting
You should see a message like this one:
Pinging <IP address> with 32 bytes of data
If the path is working, you see this message:
Reply from < IP address >: bytes=32 time=NN ms TTL=xxx
If the path is not working, you see this message:
Request timed out
If the path is not functioning correctly, you could have one of the following problems:
Wrong physical connections
Make sure the Local LNK/ACT LED is on. If the LNK/ACT LED is off, follow the
instructions in “LNK/ACT LEDs Not On”onpage 11-2.
Check that the corresponding Link LEDs are on for your network interface card and
for the hub ports (if any) that are connected to your workstation and router.
Wrong network configuration
Verify that the Ethernet card driver software and TCP/IP software are both installed
and configured on your PC or workstation.
Verify that the IP address for your router and your workstation are correct and that the
addresses are on the same subnet.