Filter
Top Products
Reference Manual for the ADSL Modem Wireless Router DG834GSP
8-6 Virtual Private Networking
v1.0, June 2007
VPN Tunnel Configuration
There are two tunnel configurations and three ways to configure them:
• Use the VPN Wizard to configure a VPN tunnel (recommended for most situations):
— See “How to Set Up a Client-to-Gateway VPN Configuration” on page 8-7.
— See “How to Set Up a Gateway-to-Gateway VPN Configuration” on page 8-21.
• See “Using Auto Policy to Configure VPN Tunnels” on page 8-38 when the VPN Wizard and
its VPNC defaults (see Table 8-2) are not appropriate for your special circumstances, but you
want to automate the Internet Key Exchange (IKE) setup.
• See “Using Manual Policy to Configure VPN Tunnels” on page 8-48 when the VPN Wizard
and its VPNC defaults (see Table 8-2) are not appropriate for your special circumstances and
you must specify each phase of the connection. You manually enter all the authentication and
key parameters. You have more control over the process, however the process is more
complex and there are more opportunities for errors or configuration mismatches between
your DG834GSP and the corresponding VPN endpoint gateway or client workstation.
Note: NETGEAR publishes additional interoperability scenarios with various
gateway and client software products. Look on the NETGEAR web site at
www.netgear.com for these interoperability scenarios.