Filter
Top Products
Reference Manual for the ADSL Modem Wireless Router DG834GSP
Virtual Private Networking 8-49
v1.0, June 2007
General. The DG834GSP VPN tunnel network connection fields are defined as follows:
• Policy Name—enter a unique name to identify this policy. This name is not supplied to the
remote VPN endpoint. It is used only to help you manage the policies.
• Remote VPN Endpoint—select the desired option (IP address or Fully Qualified Domain
Name) and enter the address of the remote VPN endpoint to which you wish to connect.
Local LAN. This identifies which PCs on your LAN are covered by this policy. For each
selection, data must be provided as follows:
• Single address—enter an IP address in the "Single/Start IP address" field. Typically, this
setting is used when you wish to make a single Server on your LAN available to remote users.
• Range address—enter the starting IP address in the "Single/Start IP address" field, and the
finish IP address in the "Finish IP address" field. This must be an address range used on your
LAN.
• Subnet address—enter an IP address in the "Single/Start IP address" field, and the desired
network mask in the "Subnet Mask" field.
• Any—the remote VPN endpoint may be at any IP address.
The remote VPN endpoint must have these IP addresses entered as its "Remote" addresses.
Remote LAN. This identifies which PCs on the remote LAN are covered by this policy. For each
selection, data must be provided as follows:
• Single PC - no Subnet—select this option if there is no LAN (only a single PC) at the remote
endpoint. If this option is selected, no additional data is required.
• Single address—enter an IP address in the "Single/Start IP address" field. This must be an
address on the remote LAN. Typically, this setting is used when you wish to access a server on
the remote LAN.
• Range address—enter the starting IP address in the "Single/Start IP address" field, and the
finish IP address in the "Finish IP address" field. This must be an address range used on the
remote LAN.
• Subnet address—enter an IP address in the "Single/Start IP address" field, and the desired
network mask in the "Subnet Mask" field.
Note: The remote VPN endpoint must have this VPN Gateway's address entered as
its "Remote VPN Endpoint".