Filter
Top Products
NTI VEEMUX VIDEO MATRIX SWITCH
13
ETHERNET CONTROL
Telnet Interface
The Telnet Interface enables the user to control the switch using telnet client through an Ethernet connection. The telnet server
listens on port 2000. To access the telnet interface, using the current IP address type the following in a command shell:
telnet 192.168.1.30 2000
The VEEMUX will prompt the user for a password. The user must enter the password followed by <Enter>.
The factory default password is "admin".
With a proper password sent the VEEMUX will respond with:
Password Successful
Connection Established
The following commands are now available:
Command Reply Description
H(elp) or
h(elp)
Displays the list of
commands
Help
CP
User is prompted to
introduce the password
twice
Change password
CS nn,mm *<CR> Connect One Output (User Port) To Input (Video source)
CA nn *<CR> Connect All Outputs To Input
RO nn *<CR>mm<CR>
Read Connection For Output.
Returns the number of the input (mm) connected to output nn
CC nn *<CR>nn<CR>
Save Matrix Connections Into Memory Bank nn
nn should be between 00 and 99
RC nn *<CR>nn<CR>
Restore Matrix Connections From Memory Bank nn
nn should be between 00 and 99
CB nn *<CR>
Change baud rate of serial line, nn=12(00),24(00),48(00),96(00)
Factory default is 9,600.
RS *<CR> Reset Unit
RV 00 *<CR>string\0<CR> Read NTI Version String
RU *<CR>nn,mm<CR>
Read Unit Size
Returns the number of inputs(nn) and the number of outputs (mm)
Ss nn,dwt *<CR>
Set value of Scan Mode dwell time (see pg. 8) for specific Output (nn)
dwt = 000-255 (seconds) 000= disable Scan Mode
Gs nn
*<CR>
dwt<CR>
Read set Scan Mode dwell time value (dwt) for specific Output (nn) in
seconds (see also "Scan Mode" on page 8)
Sa nn,mm *<CR> Set scan list of individual output nn to all inputs mm
Sc nn *<CR> Clear scan list of individual output nn
S+ nn,mm *<CR> Add input mm to Scan List of output nn
S- nn,mm *<CR> Remove input mm from Scan List of output nn
Sx nn
*<CR>oooxoxxxooooxxx<
CR>
Display the Scan List of output nn (o=skip x=don't skip)
<Ctrl>-<X>
(see note 4 below)
Good Bye.
Connection to host lost.
Quit telnet session