Filter
Top Products
NTI VEEMUX VIDEO MATRIX SWITCH
16
To save a configuraton
, from the Stored Configurations user interface, use the drop-down list to select the
desired slot (numbers 0-99) to save the active
configuration into and press the Save button.
Note: This will save the currently active configuration on
the VEEMUX. If changes have been made in the web
interface without first pressing the Submit button, those
changes will not yet be part of the active
configuration.
Note: If changes to the active configuration have been
made by another user prior to saving the current
connection selections, the changes made by the other
user will be saved as the configuration.
The webpage configuration that loads after a Save is the
configuration that was actually saved.
To load a saved configuration
, from the Stored Configurations user interface, use the drop-down list to select the
desired configuration. Then press the Load button. The VEEMUX will make the connections and the screen will
refresh to show the connections associated with that configuration selection.
FYI: Configurations saved via the keypad (pg. 7) can be recalled through this interface, and vice versa. They are one in
the same.
Setup Pages
These settings enable the user to configure the VEEMUX web interface connection. This change will take a few
seconds and automatically redirect the user to the IP address specified.
Note: Since the webserver will be restarting all active connections will be logged out.
The Website Timeout option controls how long an inactive web connection will stay logged in.
Any change to the Website Timeout configuration takes effect immediately.
Figure 10- Web interface Setup page