Filter
Top Products
NTI VEEMUX VIDEO MATRIX SWITCH
5
Connect RS232
RS232 control can be achieved using a separate user terminal or CPU with a terminal program. To make a terminal connection,
connect a serial cable (specifications on page 31) between the user terminal and the 9 pin DIN female connector on the VEEMUX
labeled "RS232". (See Fig. 3)
Figure 3- Connect user terminal for RS232 control
Connect to the Ethernet
If the Telnet Interface (page 13) or Web Interface (page 14) will be used, an Ethernet connection to the Local Area Network (LAN)
must be made using CAT 5 cable with RJ45 connectors. Wiring between the connectors should be straight through (pin 1 to pin
1, pin 2 to pin 2, etc.) Connect a CAT 5 cable between the connector label "ETHERNET" and the LAN (see Fig. 4).
Note: The Ethernet connection is not available in models in a desktop chassis (i.e. SM-8X2-15V-LCD-DT
)
Figure 4- Connect the LAN to the VEEMUX
VGA
Multi-Scan
Monitor
User Terminal
9D-male
RS232 connector
Rear View of SM-8X8-15V-LCD
7 8 5 6 3 4 1 2 8 5 6 3 4 1 2
VIDEO VIDEO MONITOR MONITOR
7
R
S
2
3
2
NTI
Tel:330-562-7070
Fax:330-562-1999
1275 Danner Dr
Aurora, OH 44202
ww w.nti1.com
R
RJ45 male
connector
LAN
Rear View of SM-8X8-15V-LCD
ETHERNET
7 8 5 6 3 4
1 2
8 5 6 3 4 1 2
VIDEO VIDEO MONITOR MONITOR
7
R
S
2
3
2
NTI
Tel:330-562-7070
Fax:330-562-1999
1275 Danner Dr
Aurora, OH 44202
ww w.nti1.com
R