Filter
Top Products
- 41 -
6. Operation
6.1 Turning on the Power
Turn the COOLSCAN II on first, the other SCSI devices next,
and the host computer last. If your scanner is the internal-
mount model, you need not turn the COOLSCAN II on.
After turning the power on, the LED will begin to blink to
indicate scanner initialization.
The scanner is self-calibrating. A calibration procedure occurs
automatically during power-up. This procedure typically takes
about twenty seconds.
Due to the patented light source, there is no warm up time
necessary for the scanner. Once the scanner has performed its
power-on calibration, it is ready to go.
Remarks
• To turn the COOLSCAN II power off, turn the host
computer off first, the other SCSI devices next, and the
COOLSCAN II last (reverse order from switching on).
• Once the power is turned off, please wait five seconds or
more before turning the power on again.
• Do not turn the power off while the scanner is scanning.
• Make sure there is no strip film holder in the scanner during
power-up, or the scanner will not calibrate correctly.
POWER ON