Filter
Top Products
9998
•Use two CR2-type 3V lithium batteries
Use two CR2-type 3V lithium batteries.
•Change the batteries well before the end of their life and prepare spare batteries
before important photographic occasions.
•Turn the camera power off when changing batteries
Turn the camera power off before changing batteries and insert the batteries with
´ and ‰ ends positioned correctly.
•Stains on the battery poles may cause lack of contact. Wipe the batteries well
with a dry cloth before installing.
•Use fresh batteries at low temperatures
Battery power diminishes at extremely low temperatures and the camera may not
function properly with old batteries. Use a fresh set of batteries at low
temperatures, keep spare batteries warm, and use them alternately.
•Film advance speed lowers and number of usable film rolls becomes less at low
temperatures. However, battery power may recover when the temperature
returns to normal.
•Do not throw batteries into a fire or short circuit batteries
Do not throw batteries into a fire. Do not short, disassemble, heat or charge
batteries.
WARNING
Do not leave
Keep batteries out of children’s
reach.
If someone accidentally swallows batteries,
call a doctor immediately.
Notes on Batteries Troubleshooting
LCD panel Viewfinder
ƒEE blinks ƒEE blinks
ƒEE blinks ƒEE and fi
blink
M appears —
M blinks —
o–– and —
frame counter
blink
ƒ-- blinks ƒ-- blinks
E appears —
Err and E blink Errblinks
Cause
• CPU Nikkor lens other
than G-type is not set to
its minimum aperture.
•Attached Speedlight is
not set at TTL Auto
Flash in
a
,Vari-
Program or P mode.
•Batteries are nearing
exhaustion.
•Batteries are just about
exhausted.
•Batteries are
exhausted during film
rewind.
•Non-CPU lens is
attached or lens is not
attached.
•Film is not correctly
installed.
•Film is not correctly
advanced.
Page
18
92
17
17
66
19,
88,
89,
90
21
21
Remedy
•Set lens to minimum
aperture.
•Set the Speedlight
flash mode to TTL, or
set the camera’s
exposure mode to S,
A or M.
•Have fresh ones ready.
•Turn the power off and
replace batteries with
new ones.
• Replace batteries with
new ones or recharge
batteries and turn the
power on again, then
press two
„
film
rewind buttons
simultaneously for
more than 1 sec. to
start film rewind again.
If this warning appears
frequently, contact
authorised Nikon dealer
or service centre.
•Attach CPU lens
(except IX-Nikkor).
With a non-CPU lens,
set the exposure mode
to M and set the
aperture with lens’
aperture ring.
•Reload film.
•Reload film.
MISCELLANEOUS
F65 (E) 02.12.27 5:43 PM Page 98