Filter
Top Products
4
Lightly press the shutter release button
to activate the exposure meter.
•Lightly pressing the shutter release button
reactivates the exposure meter and indications in
the LCD panel and viewfinder for approx. 5 sec.
See page 24 about the shutter release button.
1716
PREPARATION
1
Turn the power switch off and open the
battery chamber cover by sliding the
battery chamber cover lock lever toward
indicated direction.
•When replacing batteries, be sure to turn the power
switch off and replace both batteries at the same
time. Always use fresh batteries of the same brand.
2
Insert batteries with the ´ and ‰ ends
positioned as marked inside the battery
chamber, then firmly close the battery
chamber cover.
•Incorrect positioning of ´ and ‰ poles may
damage the camera.
3
Turn the power switch on and confirm
battery power with the N indication.
N appears: Sufficient battery power.
M appears: Batteries are nearing exhaustion.
Have a fresh set ready. (Viewfinder
indications turn off when you release
your finger from shutter release
button after taking the picture.)
M blinks: Batteries are exhausted. Replace
batteries. (Shutter locks.)
•Shutter speed and aperture indications in the LCD
panel automatically turn off 5 sec. after the power
switch is turned on and the camera remains
unused. (All indications in the viewfinder turn off.)
LCD panel when the power switch is off
When the power switch is turned off with batteries
installed, the frame counter display remains on in the
LCD panel.
Install Batteries and Check Battery Power
1
Use two CR2-type 3V lithium batteries. (For other power sources, see
page 94.)
NOTE: Storing batteries
Keep the batteries out of children’s reach. If swallowed, contact a doctor
immediately. (For “Notes on Batteries”, see page 98.)
Check points
•We recommend that you take spare batteries with you, especially when
travelling.
• For the number of film rolls that can be shot with fresh batteries, see page 110.
F65 (E) 02.12.27 5:43 PM Page 16