Filter
Top Products
Chapter 5. Setting up a SMS Gateway
Variable Value Description
msg-id-type number
Optional, specifies which
number base the SMSC is using
for the message ID numbers in
the corresponding
submit_sm_resp and
deliver_sm PDUs. This is
required to make delivery reports
(DLR) work on SMSC that
behave differently. The number
is a combined set of bit 1 and bit
2 that indicate as follows: bit 1:
type for submit_sm_resp, bit
2: type for deliver_sm. If the
bit is set then the value is in hex
otherwise in decimal number
base. Which means the following
combinations are possible and
valid: 0x00 deliver_sm
decimal, submit_sm_resp
decimal; 0x01 deliver_sm
decimal, submit_sm_resp hex;
0x02 deliver_sm hex,
submit_sm_resp decimal;
0x03 deliver_sm hex,
submit_sm_resp hex. In
accordance to the SMPP v3.4
specs the default will be a C
string literal if no of the above
values is explicitly indicated
using the config directive.
alt-charset string
Defines which character
encoding is used for this specific
smsc link. Uses iconv()
routines to convert from and to
that specific character set
encoding. See your local
iconv_open(3) manual page for
the supported character
encodings and the type strings
that should be presented for this
directive.
Sema Group SMS2000 OIS 4.0 and 5.0
The 4.0 implementation is over Radio PAD (X.28). Following configuration variables are needed, and if
41