Filter
Top Products
32 Commissioning configuration procedures
Variable Value
<hour offset> The number of hours that your local time is
offset from UTC. Enter a value from 0 to 23.
For example, if you are in New York, you enter
utc - 4.
<minute offset> The number of minutes that your local time is
offset from UTC. Enter a value from 0 to 59.
For example, if you are in New York, you enter
utc - 4 0.
Configuring the SNTP client
The Simple Network Time Protocol (SNTP) synchronizes the internal clocks
of various network devices across large, diverse networks to universal
standard time. Use the procedure in this section to enable the SNTP client
on the Secure Router 4134.
Procedure steps
Step Action
1 To access configuration mode, enter:
configure terminal
2
To set the location of the SNTP server, enter:
sntp server {ipaddr|hostname}
3 To set the timeout value for the response from the server, enter:
sntp timeout <value>
—End—
Table 10
Variable definitions
Variable Value
{ipaddr | hostname} The IP address or host name of the broadcast
server. The default value is any broadcast
server.
<value> The timeout value in seconds. The default
timeout value is 1024 seconds.
Changing the admin user password
The system administrator login consists of two components: the account
name and the password. The initial login name is always "admin". You can
change this after logging in for the first time. The default administrative
Nortel Secure Router 4134
Commissioning
NN47263-302 01.02 Standard
10.0 2 August 2007
Copyright © 2007, Nortel Networks
.