Filter
Top Products
Checking the system for alarms 39
Viewing chassis status
Use the procedure in this section to view summary information about the
Secure Router 4134 chassis, including its operational status. After you
install interface modules, you can use the show chassis command to
verify that the Secure Router 4134 recognizes the modules.
Procedure steps
Step Action
1
To view summary information about the Secure Router 4134, enter:
show chassis
—End—
Viewing interface module configuration
Use the procedure in this section to quickly check the state and configuration
of installed interface modules.
Procedure steps
Step Action
1
To view the configuration of interface modules installed in your
Secure Router 4134, enter:
show module configuration all
2
To view the configuration of individual interface modules, enter:
show module configuration [t1|e1|ct3|
serial|hssi|t3] <slot/port>
—End—
Checking the system for alarms
The Secure Router 4134 reports alarms when it detects irregular conditions
in incoming signals to the interface modules. Use the show module
alarms command to quickly check for any irregularities.
Procedure steps
Step Action
1 To view the current alarms for any T1 WAN link on the Secure
Router 4134, enter:
show module alarms t1 <slot/port>
Nortel Secure Router 4134
Commissioning
NN47263-302 01.02 Standard
10.0 2 August 2007
Copyright © 2007, Nortel Networks
.