Filter
Top Products
Menu functions - C810 > 26
COLOR
MENU
The printer automatically adjusts color balance and density at appropriate intervals,
optimising the printed output for bright white paper viewed in natural daylight conditions.
The items on this menu provide a means of changing the default settings for special or
particularly difficult print jobs. Settings revert to their default values when the next print
job is complete.
S
YSTEM
CONFIGURATION
MENU
This menu adjusts general printer settings to suit the way you prefer to work.
ITEM SETTINGS EXPLANATION
DENSITY CONTROL AUTO
MANUAL
Selecting this will permit automatic adjustment of the
color density.
ADJUST DENSITY EXECUTE Image density will be automatically adjusted at power
on, when a new image drum or toner cartridge is
installed, and at intervals of 100, 300 and 500 drum
counts. If a 500 drum count interval occurs during a
print job it will occur at the end of that job, and will
take up to 55 seconds.
AJST REGSTRATION EXECUTE Performs automatic color registration adjustment.
Normally this is done on power on and when the top
cover is opened and then closed. This process
accurately aligns the cyan, magenta and yellow images
to the black image.
C REG FINE ADJ
M REG FINE ADJ
Y REG FINE ADJ
-3~0~+3
-3~0~+3
-3~0~+3
Performs fine adjustment of image timing in relation to
the black image component.
ITEMS SETTINGS EXPLANATION
POW SAVE DELAY 5
15
30
60
240
Adjusts the idling time before the printer automatically
switches into power saving mode. In this mode power
consumption is reduced to a low level required to just
keep the printer operating and ready to receive data.
When a job is sent the printer will require a warm-up
time of up to 1 minute before printing can begin.
CLRABLE WARNING ONLINE
JOB
When ONLINE, non-critical warnings, such as requests
for a different paper size, can be cleared by pressing
the
ON LINE button. When set to JOB, they are
cleared when the print job resumes.
MANUAL TIMEOUT OFF
30
60
Specifies how many seconds the printer will wait for
paper to be fed before cancelling the job.
WAIT TIMEOUT OFF~90~300 Specifies how many seconds the printer will wait when
received data pauses before forcing a page eject. In
PostScript Emulation mode the job will be cancelled if
timeout occurs.
TONER LOW CONTINUE CONTINUE
STOP
Specifies whether the printer should continue printing
even after a low toner condition is detected.
JAM RECOVERY ON
OFF
Specifies whether the printer should perform jam
recovery after a paper jam has occurred. If ON, the
printer will attempt to print again any pages lost due to
a paper jam once the jam has been cleared.
ERROR REPORT ON
OFF
Sets whether an error report is printed when an
internal fault occurs.