Filter
Top Products
Menu functions - C810 > 27
USB M
ENU
This menu controls the operation of the printer’s USB data interface.
N
ETWORK
MENU
This menu controls the operation of the printer’s 10Base-T/100Base-TX network interface.
ITEM SETTINGS EXPLANATION
SOFT RESET ENABLE /
DISABLE
Enables or disables the SOFT RESET command.
SPEED 12 / 480 Mps Selects the interface speed.
SERIAL NUMBER ENABLE / DISABLE Specifies whether to ENABLE or DISABLE a USB serial
number.
The USB serial number is used to identify the USB device
connected to your PC.
NOTE:
When you have changed any settings in the USB MENU, turn the printer OFF, then
ON again.
ITEM SETTINGS EXPLANATION
TCP/IP ENABLE /
DISABLE
Enables or disables this network protocol.
NETBEUI ENABLE /
DISABLE
Enables or disables this network protocol.
IP ADDRESS SET AUTO / MANUAL Specifies whether IP address allocation is automatic
(DHCP) or manually assigned.
IP ADDRESS xxx.xxx.xxx.xxx Current assigned IP address. To change, press ENTER and
use up or down buttons to increment 1st octet, then press
ENTER again to move on to next octet. When 4th octet has
been set, press ENTER again to register new address.
SUBNET MASK xxx.xxx.xxx.xxx Current assigned subnet mask. To change, proceed as
above.
GATEWAY ADDRESS xxx.xxx.xxx.xxx Current assigned gateway address. To change, proceed as
above.
WEB ENABLE /
DISABLE
Enables or disables Web config. facility.
TELNET ENABLE /
DISABLE
Enables or disables Telnet config. facility.
FTP ENABLE /
DISABLE
Enables or disables communication via FTP.
SNMP ENABLE /
DISABLE
Enables or disables SNMP protocol.
NETWORK SCALE NORMAL / SMALL Selects network size.
HUB LINK SETTING AUTO
NEGOTIATE
100BASE-TX FULL
100BASE-TX HALF
10BASE-T FULL
10BASE-T HALF
Sets full or half duplex for communication via a network
hub.