Filter
Top Products
INSTALLATION > 12
INSTALLING THE ADF
1.
Remove the standard Scancopier document cover (1) by
opening the cover and lifting the studs (2) from the hinge
holes at the rear of the S700.
Store the document cover on a flat surface in a safe place.
2.
Hold the ADF document cover (3) and insert its studs (4) into
the hinge holes at the rear of the S700.
CAUTION!
In some countries the ADF is an optional accessory. As such, it can be
installed at a later time. If the Scancopier has been used previously, be
sure to switch everything off and disconnect AC power from the
Scancopier before installing the ADF.
1
2
3
4