Filter
Top Products
132
CrossFire 8600/8605 Token-Ring Switches v. 1.2, P/N: 710001641 Switch Configuration
Creating a Console Session Using a Modem
Use the
Serial Link Configuration
menu to configure the switch in order to
communicate with a console via a modem.
Set your modem according to the table below.
➽ Caution:
Some modems use slightly different names for the options. It is important
that your modem be configured correctly. The settings shown in italics are
particularly important. If your modem is not configured correctly, the connection
may cause the switch to reset.
Start the console by pressing
ENTER
. If a Telnet session is active, press
ENTER
at
the console to terminate the Telnet session and press
ENTER
again to start the
console session.
Stopping the Console Session
Pressing
CTRL-P
returns the console session to the main menu, and pressing
CTRL-
B
returns to the greeting menu.
Setting Value
Echo Off
Result codes Off
Wait for connection 45
seconds
Pause between calls 6
seconds
Drop DTR between calls Yes
Send CR between calls Yes
Auto baud detect On
Send init if CD high Yes
Maximum dial attempts 999
Table 21. Modem Settings