Filter
Top Products
69
CrossFire 8600/8605 Token-Ring Switches v. 1.2, P/N: 710001641 Connecting a Network Management Console
5. Connecting a Network Management
Console
Console interfacing can be established by connecting to the MANAGEMENT
serial port on the front panel of the CrossFire 8600 Token-Ring Switch and/or the
CrossFire 8605 Token-Ring Fiber Switch. Use this connection to set up in-band
management, which is the management of the switch
through
the network, or out-
of-band management, which is management
outside
of the network:
•
In-band management
is a network management system that works through the
network:
— Olicom Switch Manager for HP OpenView for Windows
— Other Simple Network Management Protocol (SNMP) based applications
— Telnet sessions
•
Out-of-band management
is a direct console connection to create a console
session for configuring and monitoring switches.
Network management applications (in-band management) are beyond the scope of
this guide. See the
Olicom Switch Manager for HP OpenView—Guide to
Operations
or the documentation supplied with you network management
application. How to connect the serial console (out-of-band management) for
configuring and monitoring the switch is described in this chapter.
Refer to the section “Console/Telnet Sessions” on page 130 for information on
configuring serial console and/or telnet console sessions.
Connecting the Console
The following steps explain connecting a serial terminal to the switch:
1. Connect the switch to a PC or other DTE (Data Terminal Equipment) device
using a straight, 25-pin to 9-pin TIA/EIA-232 cable (commonly known as a RS-
232 cable) and a null modem adapter or a 9-pin to 9-pin cable. See Appendix B
for a description of the cables and adapters.
2. Connect the TIA/EIA-232 cable to the DB-9 MANAGEMENT connector on
the front panel of the switch. This male DB-9 connector on the switch is
configured as a DTE device.
See Figure 20 to view the location of the cable connection on the front panel of the
switch.