Filter
Top Products
2
Recording
32
EN
Recording
Notes
• Inputting a very loud sound may produce noise
even when the Mode dial is set to [ QUICK ] or
[ SMART ].
• To ensure that you do not lose the beginning of the
recording, verify that the recording indicator light or
the mode indicator is lit on the display.
• When the remaining recording time is less than
60 seconds, the LED indicator light starts flashing.
When the remaining recording time drops to 30
and then 10 seconds, the light flashes faster.
• While adjusting the recording level manually, the
sound input may be interrupted.
• [ Folder full ] will appear when recording cannot be
continued. Delete unnecessary files or move them
to another folder before recording (
☞
P.48, P.61).
• [ Memory full ] will appear when the memory is
full. Delete unnecessary files before recording any
further (
☞
P.61).
• When an SD card is inserted into the recorder,
be sure to confirm the recording media as either
[ Internal memory ] or [ SD card ] so that there is no
mistake (
☞
P.23, P.72).
• Processing speed may be slower with some types
of SD cards. Processing performance may also be
reduced due to repeated writing and deleting. If
that happens, reformat the SD card (
☞
P.78).
• We recommend formatting the recording media in
the recorder before recording.
Recording more than 2 GB of data in
▌
linear PCM format
Recording will continue even if the volume of a single
file exceeds 2 GB in linear PCM format recording.
• The data is saved every 2 GB in separate files. It is
treated as multiple files during playback.
• If the 999th file in a folder exceeds 2 GB, recording
stops.
Settings relating to recording
▌
[ Mic Gain ] (
☞
P.66) Sets the recording sensitivity.
[ Limiter ] (
☞
P.66)
Switches the correction method
according to the sound input
when recording.
[ Rec Format ] (
☞
P.66)
Sets the recording rate for each
recording format.
[ Low Cut Filter ] (
☞
P.67)
This function can reduce
noise from air conditions and
projectors and other similar
noises.
[ Plug-in Power ] (
☞
P.67)
Selects whether or not to use
the plug-in power function
according to the external
microphone connected to the
MIC jack.
[ Mic Select ] * (
☞
P.67)
Selects whether or not the
built-in center microphone is to
be turned On or Off.
[ Pre-Recording ] (
☞
P.68)
Pre-recording enables you to
start recording up to 2 seconds
before you press the button for
recording.
[ Rec Monitor ] (
☞
P.68)
Selects whether or not to
output the recording monitor
sound from the EAR jack.
[ Smart Time ] (
☞
P.68)
You can set the time for
[ SMART ] mode automatic
adjustment.
[ Metronome ] (
☞
P.68)
You can set the metronome as a
rhythm guide during recording.
* LS-14 only