Filter
Top Products
13
Step 2 – Pseudo Calibration / Parameters
This step starts the calibration procedure. It enables to change calibration
parameters. Whether you changed the parameters or not, you may
proceed to the next step by pressing the ‘Next’ button.
Library issues:
1. Alternatively, you may click ‘Library’ in order to access the
library, as described in the ‘Calibrations Library’ section.
(If there are still no calibrations in the library, the ‘Library’
button will be inactive.)
2. Normally, upon confirming a new calibration it will be saved also
to the calibrations library. However, if you want to save it only
in the board, uncheck the ‘Save to Library’ box.
In the example below the user changed the Display Resolution parameter:
Notes
1.The changed parameter (Display Resolution) is displayed with
blue background.
2.The options list of the Display Resolution depends on the value
of Maximum Applied Capacity.