Filter
Top Products
75
E.4.4 The Filling Configurations Library
There is a ‘Filling Configurations Library’ in which you may save sets of
filling configuration parameters. This is useful in case you have more
than one type of filling, letting you switch easily and reliably from one
configuration to another.
(Note: This library has nothing to do with the calibration library
mentioned in section 3.2.2.)
Refer to the ‘Library’ box.
Save
If you like your configuration to be saved in the library, specify a Library
Name and check the option box. (It is recommended to specify a
meaningful Library Name so that later you’ll recognize the various files
you created in the library.) Your filling configuration will be saved in the
library only upon clicking the ‘Save to Board’ button. In case a library
file having the name you specified already exists, you’ll have to select
either to overwrite it, or to use another name.
Recall or Delete a File in the Library
Click the Select button in order to select a file to be recalled or deleted.
You may watch the various files and their contents. In order to delete a
file, click the Delete button. The procedure to recall a file has two or
three steps:
1. Click the Confirm button. This will insert file’s parameters to the
'Filling Definition' box.
2. Optionally, you may modify some of the parameters, thus using the
library file as a draft to make your changes easier. In case you want the
new values to be saved in a file (either the original one or another), make
sure to check the option in the ‘Library’ box.
3. Click the ‘Save to Board’ button.