Filter
Top Products
38
Section 3 Reading 2D Code
V400-H111/211
User’s Manual
Section 3
Reading 2D Code
Reading 2D Code
■ Trigger Buttons
The trigger buttons located on the left and right sides of the Handheld 2D Code Reader
perform the same operations.
When a trigger button is pressed, the 2D Code Reader will start reading code.
■ Trigger Mode
Triggers can be input two different ways. Select the input method to suit the required
application.
◆ Level Trigger (Factory setting)
The 2D Code Reader repeats reading while a trigger button is held down.
Reading will be stopped when the code has been read successfully or when the trigger
button is released.
◆ Alternate Trigger
Once a trigger button is pressed, reading will be repeated even after the trigger button
is released.
Reading will be stopped when the trigger button is pressed again or when the code has
been read successfully.
■ Zoom Lever
The zoom lever is used to change the field of
vision to suit the size of the code to be read.
Model Setting range
V400-H111 5 mm (TELE) to 10 mm (WIDE)
V400-H211 15 mm (TELE) to 30 mm (WIDE)