Filter
Top Products
6
Introduction
V400-H111/211
User’s Manual
Introduction
Always observe the following precautions to prevent operation failures, malfunctions, and
adverse effects on performance and equipment.
■ Operating Environment
Do not install the product in the following locations:
• Locations subject to ambient temperature that exceeds the rated temperature range
• Locations subject to rapid changes in temperature (causing condensation)
• Locations subject to relative humidity that exceeds the rated humidity range
• Locations subject to corrosive or flammable gases
• Locations subject to dust, salt, or metallic powder
• Locations subject to direct vibration or shock outside the specified ranges
• Locations subject to direct sunlight
• Locations subject to oil or chemical spray
■ Installation and Handling of Components
• Use the cables specified in this manual.
p.18
■ Connecting and Removing Cables
• Do not connect a cable to the Handheld 2D Code Reader if the other end of the cable
is connected to a personal computer or a Programmable Controller.
• To prevent damage from static electricity, use a wrist strap or another device for
preventing electrostatic charges when touching terminals or signal lines inside
connectors.
■ Memory Cards
• Do not remove the Memory Card when the Memory Card indicator is lit. Doing so may
result in damage to the Memory Card or the Handheld 2D Code Reader.
• OMRON shall not be responsible in any way for damage or loss of Memory Card data
as a result of mishandling.
p.32
■ Turning OFF the Power Supply
• Do not turn OFF the power supply while a message is being displayed indicating that
processing is being performed. Data in memory will be destroyed, and the product
may not operate correctly the next time it is started.
Precautions for Correct Use