Filter
Top Products
53
V400-H111/211
User’s Manual
Section 4 Uploading from the Memory Card
Section 4
System Settings
Uploading from the Memory Card
The Memory Card can be used to upload the setting data to the Handheld 2D Code Reader. The
following procedure needs to be performed to reflect the changes made on a Code Reader to
two or more Code Readers or to reflect the data set using “2DCR Configear” to a Code Reader.
Starting Setting Mode
1. If the data is created using “2DCR Configear”, the data must be saved to the Memory Card.
To save data to the Memory Card, create a folder with the name SETTINGS, and save. If the data is
saved to a folder other than “SETTINGS”, it cannot be uploaded.
2. Start setting mode.
Setting mode can be started by the following two methods.
A Turn ON the power to the Code Reader
while holding both right and left trigger
buttons.
B Insert the Memory Card into the slot while
holding both right and left trigger buttons.
The setting mode menu window will be displayed.
When using the
AC adapter
When using the
power supply