Sylvania ML-1 Webcam User Manual


  Open as PDF
of 22
 
Using the Remote
How do I use zones to select source?
Select the desired zone by pressing Z1-Z5 or AZ for all zones. There is a user applied scker that can be
aached to your remote to record which rooms are set for which zones. Then select a source: S1, S2 or S3 (see
FIGURE 7) .
How do I use zones to adjust light or volume?
Select the desired zone by pressing Z1-Z5 or AZ for all zones. Then, to adjust audio press +, - or mute. For
lighng press +, - or on/o (see FIGURE 7).
NOTE: You must set the House Code dial prior to rst use to match the MusicLites and transmiers (see
FIGURE 7).
How do I replace the baery in my remote?
To replace the baery, ip the remote to the back side, depress the latch on the baery access tray and pull
the tray to slide open, exposing the baery. Take note of the “+” indicator facing up on the tray. Remove the
current baery and replace with a new standard CR2025 lithium coin baery. Be sure the “+” indicator is
facing up on both the tray and the baery itself. Carefully slide the tray back into the remote housing unl you
hear a click. You are now ready to use your remote.
FIGURE 7
House Code
Baery
Drawer
ZONE LOCATION
1._________________
2._________________
3._________________
4._________________
5._________________
Zone
Locaon
Scker
Zones
Sources
Volume
Controls
Dimming
Light
On/O
Mute
11
 previous next