IMPORTANT SAFETY INSTRUCTIONS
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS
BEFORE OPERATING THIS EQUIPMENT.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.
To avoid injury and/or property and product damage:
• Do not install this product anywhere it may be in direct contact with water or exposed to rain or moisture.
• Keep remote control, baeries, included scredriver and other small devices away from children.
• Do not use or install this product outdoors.
• Clean this product only with power disconnected and only with a clean, dry cloth.
• Only install this product in xtures that can sturdily support weights of at least 1.5lbs (681 g).
• Use proper and safe bodily support when installing product in high locaons.
• Use only in xtures rated for the appropriate lamp waage.
• Refer all servicing to qualied service personnel.
To avoid damage by possible re:
• Do not block product’s venlaon openings.
• Do not install near heat sources such as radiators, heat registers, stoves or other heat-generang appliances.
CAUTION
• This product is not intended for use in emergency light xtures or exit signs.
• Use only accessories specied by the manufacturer.
• To prevent early lamp failure, lamp should only be installed in operang environments ranging between -40
degrees Fahrenheit and +113 degrees Farenheit (-40 degrees Celcius and +45 degrees Celcius).
WARNING
2
MPE Reminding
1. The installed antennas must not be located in a manner that allows exposure of the general populaon at a
distance of less than 20cm.
2. Mount the antennas in a manner that prevents any personnel from entering the area within 20cm from the
central posion of the antenna.
To sasfy FCC RF exposure requirements, a separaon distance of 20 cm or more should be maintained
between this device and persons during device operaon.
To ensure compliance, operaons at closer than this distance is not recommended. The antenna used for this
transmier must not be co-located in conjuncon with any other antenna or transmier.