Filter
Top Products
You should now be able to control the ML volume with both the device and the remote control. If you
would like to use only one device to control audio volume, turn the volume to the highest sengs on the
device you do not want to use. This will give you full audio range. For instance, turning your computer
volume to full will allow the MusicLites remote to control volume for the full capability of the MLs and
your computer.
Make sure the house code is set to the proper code (default is 0). If not, take the screwdriver provided
and turn to the correct house code.
Decide what source you want it to play as. There is a sliding switch with 3 posions on the side of the
transmier. Slide it to S1, S2 or S3.
Plug one end of the power adapter provided into the DC port of the Toslink and the other end into the
wall outlet. The Universal transmier will not work without power. The red indicator should light up to
indicate that power is established. Then connect the opcal cable into the Opt Port of the transmier and
connect to the television or receiver output. You will need to consult with your owner’s manual to make
sure you are ulizing the correct port of the television or receiver.
Make sure the MLs that you want to play are turned on (see ML set-up secon for details). Use the
remote to make sure the MLs are looking to play from the source 1, 2 or 3 you picked (again, check the
ML set-up secon for how to do this).
There should be no need to check your output device since the connector of the Toslink plugged into
your device will automacally divert the audio signal to the transmier. If it does not check to make sure
everything connecon is ght.
Pick something with audio to play and start it. The light on the transmier should begin to blink between
red and blue as it searches for synchronizaon with the MLs.
When synchronizaon is made, the light will be blue. The MLs will also have a blue light that will light
up momentarily as it receives the signal. The MLs should begin playing. You can use your device to set
audio levels for the MLs. You should not need to adjust bass, treble, etc. and you will want to remove any
exisng EQ or tone sengs. If synchronizaon is not made, you may need to check with your sources to
make sure the MLs and the transmier are set for the same source. Also, make sure your device is not set
on mute. You may also want to check the MLs to make sure they were not inadvertently muted from the
remote control.
You should now be able to control the audio volume with both the device and the remote control. If you
would like to use only one device to control audio volume, turn the volume to the highest sengs on the
device you do not want to use. This will give you full audio range. For instance, turning your computer
volume to 100% will allow the MusicLites remote to control volume for the full capability of the MLs and
your computer.
(8)
How do you connect the Universal Transmier to a television or receiver?
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
18