Panasonic AV-HS300G Switch User Manual


 
28
3. Setup
3-1. Setting the input signals
3-1-1. Setting the input signals (IN 1 to 5)
If HD has been selected as the system format, SDI or analog HD component can be selected for each input.
This selection is possible only when the HD analog board has been connected.
1 Press the [FUNC] switch to light its indicator, and then press the [SETUP] switch to display the SETUP
menu.
2 Turn [F1] to display the IN1 to 5 menu.
3 Turn [F2], select the input signals using the SIG item, turn [F3], and select SDI or ANLG (analog HD
component) using the MODE item.
4 If analog HD component has been selected, turn [F4], and set the gain of the input signals using the GAIN
item. The gain can be set within the 30-step range, and the setting will result in changes of 2 dB.
The amount by which the gain changes per step is not the same for each step.
ANLG IN2
IN3
IN4
IN5
IN1-5
1/15
SIG
IN1
MODE
SDI
GAIN
-
-30—30
3-1-2. Setting the input signal frame synchronizer
The frame synchronizer can be set to ON or OFF for each input.
The input 6 (DVI input) frame synchronizer is permanently ON. It cannot be set from ON to OFF or vice versa.
1 Press the [FUNC] switch to light its indicator, and then press the [SETUP] switch to display the SETUP
menu.
2 Turn [F1] to display the FS menu.
3 Turn [F2], select the input signals using the SIG item, turn [F3], and select ON or OFF for the frame
synchronizer using the FS item.
0''*/
*/
*/
*/
'4

4*(
*/
'4
0/
AVDL function is active while the frame synchronizer function is set to OFF.
The AVDL function automatically adjusts the input image signal phase to the horizontal synchronization
reference signal phase.
For details, refer to “3-6. Adjusting the output signal phase”.