Filter
Top Products
Customizing Your Machine
193
Fax Parameter Table
Setting Your
Machine
097 Special Tray
No.1 - 3
*None Select up to 3 Special Trays that will not be used for printing received
faxes. One Tray must always be available for receiving Faxes.
(You can specify one Tray (1 ~ 3) for each selection No. 1, No. 2, and/or
No 3.)
Tray 1
Tray 2
Tray 3
099 Memory Size
(Flash Memory)
- Displays the amount of base, and optional memory installed.
(Base Memory + Optional Memory)
118 FAX Function Detect Invalid Setting the number of digits for detecting a Fax Telephone number.
Upon detecting the specified number of digits, the machine will
automatically switch to the FAX Mode when it is in the Copier Mode.
4-Digits
5-Digits
*6-Digits
7-Digits
8-Digits
131 Job Tracking *None Selecting Job Tracking function.
None : Does not function.
TX : Valid only in sending.
Rx : Valid only in receiving.
Tx&Rx : Valid both in sending, and receiving.
Note: • Before performing this setup, you first need to set the FAX
FORWORD (Fax Parameter No. 054) parameter to Invalid.
• Copy, Fax, Scanner, or Printer in the User Authentication
(General setting - Key Operater Mode No. 050)need to set
"Valid".
Tx
Rx
Tx&Rx
132 Via Fax Server
Fax Server Mail Address
*Invalid Enter the Email address of the RightFax server when you enable the
RightFax function for the first time.
Note: • Before performing this setup, you first need to set the User
Parameter setting (General setting - Key Operater Mode
No. 000) in the Genral settings (For Key Operator) and, FAX/
EMAIL Settings (For Key Operator).
Valid
140 LAN RLY XMT Request *Invalid Selecting whether the machine performs LAN Relay XMT Request.
Valid
141 LAN XMT Reduce *Invalid Selecting whether to automatically reduce from LEDGER / B4 to A4,
when LEDGER / B4 documents are transmitted via LAN.
Invalid :No reduction
Valid :Automatic reduction from LEDGER / B4 to A4
Valid
142 Relay XMT Invalid Selecting whether the machine accepts, and performs G3 relayed
transmission. (Relay Station Functions)
*Valid
143 Relay XMT Report Off Setting how the COMM. Journal for relayed transmission is sent to the
originator.
Off : Don’t send.
Always : Always send.
Inc. only : Send only if communication has failed.
*Always
Inc. only
* = Factory default setting
No. Parameter Setting Comments
Continued on the next page...