1.13. INSTALLATION
1.13.1. INSTALLING THE RECORDING PAPER
Open the cover by pressing the cover open button
and install the recording paper roll.
If the paper is secured with glue or tape, cut
approximately 15 cm (6 inches) from the
beginning.
correct
incorrect
Tear off the excess paper by pulling it
towards you.
Close the cover securely by pushing down on
both ends.
Pull the leading edge of the paper approximately
10 cm (4 inches) out of the unit.
Make sure that there is no slack in the
paper roll.
Cover open
button
10 cm
1
2
3
4
Note:
Only use the included roll of paper or specified recording paper, or else the print quality may be affected and/or excessive
thermal head wear may occur.
For accessory order information.
When the power cord is connected, every time you close the cover a message will be printed. If the recording paper is set to
the wrong side, the message will not be printed. Install the paper correctly.
1.13.2. Document Stacker
Install the document stacker.
11
KX-FT21RS